DOI : 10.1140/epjad/i2005-06-110-5

this paper reported a first spin polarized proton solid target under low magnetic field ( 0.08 T ) and hight temperature ( 100K )

the introduction overview the motivation of a solid target.

  • a polarized gas target is ready on many nuclear experiment.
  • on the radioactive beam ( IR beam ), the flux of a typical IR beam is small, since it is produced by 2nd scattering.
  • a solid target has highest density of solid.
    • most solid target can only be polarized on low temperature ( to avoid environmental interaction to reduced the polarization )
      • increase the experimental difficult, since a low temperature should be applied by a cold buffer gas.
    • high field ( the low gyromagnetic  ratio ).
      • high magnetic field make low energy scattered proton cannot get out from the magnetic field and not able to detect.
  • a solid target can be polarized at high temperature and low magnetic field is very useful

the material on use is a crystal of naphthalene doped with pentacene.

the procedure of polarizing the proton is :

  1. use optical pumping the polarize the electron of pentacene
    • the population of the energy states are independent of temperature and magnetic field.
  2. by Dynamic Nuclear Polarization (DNP) method  to transfer  the polarization of the electron to the proton.
    • if the polarization transfer is 100% and the relaxation time is very long. the expected polarization of proton will be 72.8%

The DNP method is archived under a constant microwave frequency with a sweeping magnetic field. when the magnetic field and  microwave frequency is coupled. the polarization transfer will take place.

the next paragraph talks about the apparatus’s size and dimension, in order to fit the scattering experiment requirements.

the polarization measurement is on a scattering experiment with 6He at 71 MeV per nucleons. By measuring the polarization asymmetry \epsilon , which is related to the yield. and it also equal to the polarization of the target P_t  times the analyzing power A_y .

\epsilon = P_t \times A_y

with a reasonable guess of the target polarization. the analyzing power of  6He was found.

the reason why the polarization-asymmetry is not equal to the analyzing power is that, the target is not 100% polarized, where the analyzing power is defined. when the polarization of the target is 100%, both are the same.

in the analysis part. it used optical model and Wood-Saxon central potential to simulate the result. And compare the result from 6He to 6Li at same energy. the root mean square of 6Li is larger then 6He. it suggest the d-α core of 6Li may responsible for that.

they cannot go further discussion due to the uncertainly on the polarization of the target.

Advertisements